Two Pole Switch Manufacturer is often used in daily life. Each household is inseparable from the use of electricity. Once there is no one, all electrical appliances will be paralyzed. , Directly find a way to repair it! What should I do if Two Pole Switch Manufacturer is broken? Don't ask this question. First find the cause of the damage, and then repair it according to the actual situation. Do you know the correct method and see the analysis below.
1. Two Pole Switch Manufacturer causes damage
1. The reason why Two Pole Switch Manufacturer is broken. There are generally two cases, one is the poor contact of the Two Pole Switch ManuFactuerr panel.
2. For poor access to the socket, you can only replace the new Two Pole Switch Manufacturer; and for the power cord deficiency, you can perform maintenance.
Second, Two Pole Switch Manufacturer
1. Disassemble Two Pole Switch Manufacturer
After determining that Two Pole Switch Manufacturer was damaged, remove the Two Pole Switch Manufacturer panel with a screwdriver, and the screw knife twists the screws on both sides of the Two Pole Switch Man function.
2. Wiring
(1) If it is a power cord virtual connection, you can tighten the screws of the wiring column. If you want a new Two Pole Switch Manufacturer, you can twist the screws on the wiring column to the most loose, and connect the scope, fire lines, and ground wires respectively. In the line column.
(2) Note that the wiring pillar of the letter L is connected to the cable, the wiring column marked with the letter n connects the zero line, and the other wiring column connects the two -color ground wire. Do not hurt the core or connect errors.
3. Check whether it is well repaired
Put the insertion and re -seat on the fixed position, screw the left and right screws, and put the empty push open and test in front of the Two Pole Switch Manufacturer panel. If you have a problem, you need to check the fault until it can be used normally.
two pole switch manufacturer https://www.tangrammould.com/Two-Pole-Switch.html
